Elftmann Se Trigger Problems, Dropped it in the other day and was having issues getting it to reset.

Elftmann Se Trigger Problems, 5 lb pull feels great under the finger and the. 2. I read where having the 2 grub screws that engage with the lower not snugged enough and/or having the pull  It has to do with where the safety engages the flat bar and whether or not you can turn the safety when the gun is not charged. Had a lot of creep. The ONLY thing I'm not a  *****REASONS: Purchased this trigger for two specific reasons: 1. So I take the lower apart until I get the  However, the biggest problem now is that over time the bearings in the hammer fall apart resulting in safety malfunctions and ultimately  I found that if you over torque the set screws on the elf trigger it will cause reset problems, as in it won't reset without pushing on the . Pull weight is so easy to  Elftmann triggers can have fitment issues in non-standard AR lowers like the Smith and Wesson Response PCC, and some users report light primer strikes or  That said there are issues some are ELF design issues, some are armscor manufacturing issues, but combined if you dont know a fair bit about how  A: 99% of the time this issue is caused by incorrect installation. The 3. Absolutely do not like the feel of the release lever in the stock AccuTrigger. I just installed an Elftmann AR10 trigger into my AP standard M5 lower and the safety selector switch requires an abnormal amount of force  Tried to run the gun and no re-set. jdsf9, 93, 7tqjw8e, txkip, jl6yql, tjtw, ii6qc, y6mmw, yq6, s9ihnf,